Belysning/Dekorativ/LED Strips

SmartLife LED-Bånd

Wi-Fi | Cool Hvid / RGB / Varm Hvid | SMD | 5.00 m | IP44 | 2700 - 6500 K | 960 lm | Android™ / IOS

Funktioner

Producentens varenummer: WIFILS50CRGBW
EAN nummer: 5412810303106
• Nem opsætning - du skal bare forbinde til dit Wi-Fi for at indstille, betjene og lave tidsplaner for LED-strimlen
• Du kan vælge røde, grønne og blå farver er, eller du kan vælge en nuance fra varm til kølig hvid - der passer perfekt til dit humør
• Strimlen kan forkortes eller forlænges - der er uendelige muligheder
• Klæbende på begge sider (3M), der allerede er sat på - sikrer nem fastgørelse
• Fungerer som et separat lys - eller kombiner den med andre SmartLife-produkter for at skabe et smart hjem
Brug denne smarte LED-strimmel til at sætte stemningen i ethvert rum. Kontrollér den i Nedis SmartLife-appen, indstil tidsplaner eller automatiseringer, eller brug dine foretrukne stemmeassistenter til at kontrollere lysstyrken og farven på LED-strimlen. Den sluttes direkte til dit Wi-Fi-netværk uden brug af særskilt hub.
Da denne LED-strimmel kombinerer både RGB og varme og kolde hvide LED'er, kan du ikke kun indstille en hvilken som helst foretrukken farve, men også bruge den til varm og kold hvid indirekte belysning
Dens 5 meter kan afkortes eller forlænges med lignende LED-strimler for uendelige muligheder
Det dobbeltklæbende tape (3M) er allerede sat på den, så den er nem at montere på en ren og flad overflade.

Emballage

Pakkens indhold

RGBW LED-strimmel (5 m)
Wi-Fi-styring
Strømforsyning
Lynvejledning

Detail mål på pakker Gaveæske med eurolock

Bredde Højde Længde
50 mm 190 mm 185 mm

Logistik dimensionerne

Pakket per Bredde Højde Længde Vægt
1 182 mm 50 mm 210 mm 420 g
8 195 mm 245 mm 420 mm 3720 g
32 410 mm 440 mm 510 mm 16000 g

Produktspecifikationer

Bredde 151 mm
Højde 8 mm
Dybde 5000 mm
Vægt 310 g
Indgangsspænding 220 - 240 V AC 50/60 Hz
Maksimal transmissionsantenneforstærkning 2.5 dBi
Kompatibel med Nedis® SmartLife
Strømadapterkabel længde 1.50 m
Maksimal transmissionseffekt 16 dBm
Farvegengivelsesindeks (Ra) 80
Lys farve Varm Hvid
Cool Hvid
RGB
App tilgængelig til Android™
IOS
Kapslingsklasse IP44
Maksimalt strømforbrug 15 W
Stik Euro (CEE 7/16)
Dimbar Ja
Pærens nominelle levetid 20000 h
Understøttet trådløs teknologi Wi-Fi
Skærbar Ja
Energiforbrug pr. 1000 timer 15 kWh
Materiale Silikone
Beslag Overflademonteret
Light strips som kan udvides Ja
Frekvensområde 2412 - 2484 MHz
Antal produkter i pakken 1 stk.
Enhedens strømindgangsforbindelse DC
Farvetemperatur 2700 - 6500 K
Energiklasse F
Nominel lysstrøm 960 lm
Farve Flerfarvet
Ledningslængde 5.00 m
LED Type SMD
LED-moduler SMD 5050
Antal LED per meter 90 stk.

Support

Ofte stillede spørgsmål

Vi har fundet følgende spørgsmål til dig på engelsk

No, the LED's are not individually addressable.

Please try the AP mode.

Make sure that you use a 2.4Ghz wifi network.

Reset the controller so the LED strip blinks slow. (press and hold the button on the controller)

If it blinks fast, reset it again and it will blink slowly



In the app:

+ > [your device] > tap on EZ mode and select AP mode > confirm it was reset > fill in the info of your wifi network > follow the steps in the app.



Hold your phone very close to the plug during the installation

This method uses a direct connection to the device to send the info of your wifi to it.

Holding it close optimises this connection

Ensure that you only take off the plastic protection and not the entire adhesive strip.
If you remove the whole strip, you will not be able to stick it to anything.

Yes, you can purchase another set and plug the second strip in the first one.
If you extend it to 10m (5m extra) then you might see some loss in brightness at the end of the second strip.
We recommend you install multiple complete sets and group them in the app.
Now you can control all of the strips as if they are a single strip without any loss in brightness.

Yes you can.
Each person needs a unique account on their mobile device.
To add them as "family members" follow these steps:
In the main screen of the app tap on the name of your home (top left)
Tap on Home management
Tap on the name of your home again.
Tap on "add family members" and fill in the account details of the person you want to add.
It will give them access to all the devices in your home as a normal member or admin (you can select this)

If you only want to share a single device in a home, go to the settings menu of the device and select "share device" -> add member.

This is probably a Wifi problem, this can be for various reasons.
1.) Wifi signal is unstable.
2.) Wifi signal is too weak.
3.) Using an access point with the same SSID and password that do not support the IEEE 802.11R standards.

Problem 1 can often be solved by restarting the router.
Problem 2 can be checked with an app Wifi analyzer with this the signal can be viewed and corrected to a better position.
Problem 3 can be checked as the access points are turned off, the Wifi signal is still good and the connection remains if the access points are a problem, a Mesh solution can then be used.
Please make sure that they support IEEE 802.11R standard.